Manual control

Introduction

In some applications you may want to change some parameters manually during a run. This section exemplifies how you can change the pump flow manually.

How to change the pump flow

The table below describes how to change the pump flow.

Step

Action

1

Select Manual:Pump.

Result: the System Pump Instructions dialog box opens The Pump radio button is selected.

2

Click the function you want to change, i.e. Flow.

3

Enter a new value (FlowRate) under Parameters. You can use the arrows to step the value up or down.

4

  • Click Execute to execute the instruction immediately.

or

  • Click Insert to add the instruction to the list below the instructions menu.

Note: If there are instructions on the list, the Execute button will execute all instructions on the list at the same time.

5

Click Close to close the dialog box.

The System Pump Instructions box

The illustration below shows the System Pump Instructions dialog box:

Note: The parameter values will be updated continually during the run if the Auto update checkbox is selected.

How to end your run manually

Click the End button to end the method run before it is finished. You can save the partial result the same way that you save a completed run.

2005-06-15